IBM iL2120 User Manual page 16

Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
— Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration
of this product during an electrical storm.
— Connect all power cords to a properly wired and grounded electrical outlet.
— Connect to properly wired outlets any equipment that will be attached to this product.
— When possible, use one hand only to connect or disconnect signal cables.
— Never turn on any equipment when there is evidence of fire, water, or structural damage.
— Disconnect the attached power cords, telecommunications systems, networks, and modems before
you open the device covers, unless instructed otherwise in the installation and configuration
procedures.
— Connect and disconnect cables as described in the following table when installing, moving, or
opening covers on this product or attached devices.
To connect:
1. Turn everything OFF.
2. First attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
Connecting a computer
The projector comes with an M1-DA analog computer cable. If your computer
has a digital output, you can use the optional M1-DA digital computer cable,
sold separately at http://www.infocus.com/.
1. Plug the end of the M1-DA analog computer cable marked A into the
connector marked AD on the projector.
2. Plug the blue monitor end of the M1-DA analog computer cable into the
video connector on your computer.
6
iL2120 IBM Value Data/Video Projector, iL2220 Conference Room Data/Video Projector: User's Guide
To disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.