IBM iL2120 User Manual page 32

2. Highlight Manual tracking, and then press the left or right navigation
button repeatedly until the fuzzy vertical bars are gone.
Horizontal position
Follow these steps to manually adjust the horizontal position:
1. Turn Auto Image off.
2. Highlight Horizontal position, and then press the left navigation button to
move the image right, or press the right navigation button to move the
image left.
Vertical position
Follow these steps to manually adjust the vertical position:
1. Turn Auto Image off.
2. Highlight Vertical position, and then press the left navigation button to
move the image down, or press the right navigation button to move the
image up.
Positioning adjustments are saved when you turn off the projector.
Controls menu
The following settings allow you to adjust the controls.
Note: If you already know the video standard that is used in your
Video standard
When Video standard is set to Auto, the projector attempts to select the video
standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL-60, or SECAM)
automatically based on the input signal that it receives. (The video standard
22
iL2120 IBM Value Data/Video Projector, iL2220 Conference Room Data/Video Projector: User's Guide
Display Audio Image
geographical area, it is often best to manually select it.
Controls Language
> >
Video standard
Standby time
Ceiling projection
Rear projection
Default source
Auto source select
Plug and Play
Display messages
Display startup screen on
Status
1 minute
off
off
computer 1 analog
off
off
on