1. Manuals
  2. Brands
  3. Philips Manuals
  4. LED TV
  5. 50HFL3683S
  6. Quick start setup manual

Philips 50HFL3683S Quick Start Setup Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Quick Start Setup Guide
50HFL3683S

Advertisement

Table of Contents
loading

Related Manuals for Philips 50HFL3683S

Summary of Contents for Philips 50HFL3683S

  • Page 1 Quick Start Setup Guide 50HFL3683S...
  • Page 2 To prevent electric shock, match wide blade of plug to wide slot, fully insert. ATTENTION: Pour éviter les choc électriques,introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’au fond. Visit our World Wide Web Site at www.philips.com/support www.philips.com/hospitality...

  • Page 3: Important Safety Instructions

    • If installed onto a ceiling or slanted wall, the TV and Wall M6 x 1.614” (41mm) Mount Bracket may fall which could result in a severe injury. 50HFL3683S SQM6485/17 with spacer • Do not use screws that are longer or shorter than their specifi...

  • Page 4: Warranty

    The user could lose the authority to operate this apparatus if an Trademarks are the property of Koninklijke Philips Electronics N.V. or unauthorized change or modifi cation is made. their respective owners.

  • Page 5: Environmental Care

    Do not insert the AC power cord into the power socket outlet according to all local, state and federal laws. before all the connections are made. Philips pays a lot of attention to produce environment-friendly • Ensure that you always have easy access to the AC power cord products in green focal areas.

  • Page 6: How To Use This Guide

    How to use this guide TV Setup The Quick Start Setup Guide helps you install the Philips Philips Hospitality TVs have a USB cloning capability so you commercial television, as quickly as possible. It contains the only need to manually setup one TV - the “master TV”. Then necessary information to install the TV and confi...

  • Page 7: Channel Installation

    Channel installation This section describes how to install the TV channels automatically. Connect the RF signal to the TV. Plug the power cord into the power outlet. ANT. IN Cable Turn the TV on. • Press . POWER at the front of the TV or use the .
  • Page 8 DATA DATA (RJ-12 SPI port) Digital audio output jack Component / Composite (VIDEO) Video Input jacks for VIDEO Analog audio (L/R) Input jacks e HDMI Input jack(s) f PC Input jack g USB terminal h Antenna Input jack i Headphone 3.5mm stereo jack for personal listening...

  • Page 9: Confi Gure The Switch On Settings

    Confi gure the Switch on settings Confi gure the Control settings Press MENU and select Switch on settings. Press MENU and select Control settings. Press Î or ï to select the desired mode, then press Press Î or ï to select the desired mode, then press TV RC Sets the TV operative or inoperative by guest remote Switch on...

  • Page 10: Changing Picture And Sound Settings

    Changing picture and sound settings TV to USB Connect your USB storage device to the USB port on You must set Home in Location. Otherwise, these settings the side of your TV. will not be memorized after the unit goes to standby mode. Press MENU and select TV to USB.
  • Page 12 P&F Mexicana, S.A. de C.V. Av. La Palma No. 6, Col. San Fernando La Herradura, Huixquilucan Edo. de México C.P. 52787 Philips and Philips Shield are used under license of Koninklijke Philips Electronics N.V. Printed in China A21UZUH 1EMN29799 ★★★★★...

Table of Contents