Address Switches - Sanyo COOL Installation Instructions Manual

5. Address Switches

Change the address switch to prevent mixing of sig-
nals from remote control units when 2 Sanyo air con-
ditioners are installed next to each other. Normally,
the address switch is set to A. To change the address
to B, break tab A of the remote control address switch
and cut the jumper cable (JP11) on the indoor unit
board. (Figs. 32 and 33)
If you need more information, contact your air condi-
tioning system dealer.
Normally, the tabs on the remote control unit should
not be broken.
JP11
Address switch
(tab A)
The illustration above pictures the remote control
NOTE
unit after the cover has been lowered and removed.
Fig. 33
15
Fig. 32