Table of Contents
Advertisement
Fixing the System
If the projector's network configuration is completely wrong and you cannot
fix it:
Setup problems
If you cannot change settings using a Web browser:
If you cannot install Wireless Presenter-to-Go on your computer:
56
an Infrastructure connection. For more details, see Chapter 2,
"Presenting from a Networked Computer," on page 17 or Chapter
3, "Presenting from a Wireless Handheld Organizer," on page 29.
❏
Reset the projector's network configuration to the factory default
values. To do this, turn off the projector and allow it to cool,
then turn off the main disconnect switch. Insert a straightened
paperclip into the small hole on the module below near the USB
ports. While pressing the small button inside, turn on the main
switch and continue holding the button for at least 15 seconds.
❏
Contact your network administrator to determine the proper
settings for your network.
❏
If you cannot connect to the projector using a Web browser, see
the previous problem above.
❏
If you cannot access or edit certain pages, the Web interface
has been protected by the Web administrator. Contact the
administrator.
❏
If the administrator password has been forgotten, reset the
network configuration to the factory default values. See the
previous problem above.
❏
Be sure your computer meets the minimum requirements for
Wireless Presenter-to-Go. See "To prepare your computer for
networked presentations" on page 18 for more information.
❏
If an earlier version of HP Wireless Presenter-to-Go is installed
on your computer, try uninstalling it before installing a new
version.
User's Guide
Advertisement
Table of Contents
