Main Menu
The BIOS Setup is accessed by pressing the DEL key after the Power‐On Self‐Test (POST)
memory test begins and before the operating system boot begins. Once you enter the BIOS
Setup Utility, the Main Menu will appear on the screen. The Main Menu provides System
Overview information and allows you to set the System Time and Date. Use the "<" and ">"
cursor keys to navigate between menu screens.
M a i n A d v a n c e d B o o t C h i p s e t P o w e r S e c u r i t y E x i t
System Date [Tue 01/14/2010]
System Time [10:18:15]
> SATA 1 :[WDC WD1600BEV]
> E‐SATA :[Not Detected]
> System Information
Below table is described for SATA1 and E‐SATA setting.
M a i n
A d v a n c e d B o o t C h i p s e t P o w e r S e c u r i t y E x i
Primary Master
Device :Hard Disk
Vendor :WDC 1600BEVT‐00ZCT0
Size: :160.0GB
LBA/ Large Mode [Auto]
DMA Mode [Auto]
S.M.A.R.T [Auto]
LBA/ Large Mode [Auto]
Enables or disables the LBA (Logical Block Addressing)/ Large mode. Setting to Auto
enables the LBA mode if the device supports this mode, and if the device was not
previously formatted with LBA mode disabled.
QutePC‐1010 User's Manual
Table 2 BIOS Main Menu
BIOS SETUP UTILITY
V02.61 (C)Copyright 1985‐2006, American Megatrends, Inc.
Table 3 IDE Device Setting Menu
BIOS SETUP UTILITY
V02.61 (C)Copyright 1985‐2006, American Megatrends, Inc.
26
Chapter 3
Use [ENTER], [TAB]
or [SHIFT‐TAB] to
select a field.
Use [+] or [‐] to
configure system Time.
<> Select Screen
↑↓ Select Item
+‐ Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Disable: Disables LBA Mode.
Auto: Enables LBA Mode if the
device supports it and the device
is not already formatted with LBA
Mode disabled.
<> Select Screen
↑↓ Select Item
+‐ Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
t