Removal Of Hv Battery - Toyota Highlander GVU48 Series Dismantling Manual

Removal of HV battery

WARNING:
・ Be sure to wear insulated gloves when handling high-voltage parts.
・ Even if the vehicle is shut off and the relays are off, be sure to
remove the service plug grip before performing any further work.
・ Power remains in the high voltage electrical system for 10 minutes
even after the HV battery pack is shut off because the circuit has a
condenser that stores power.
・ Make sure that the tester reading is 0 V before touching any
high-voltage terminals which are not insulated.
・ The SRS may remain powered for up to 90 seconds after the vehicle
is shut off or disabled. To prevent serious injury or death from
unintentional SRS deployment, avoid cutting the SRS components.
1. Shut off the ignition (READY indicator is off).
2. Disconnect the cable from the auxiliary battery
negative (-) terminal.
3. Disconnect the cable from the auxiliary battery
positive (+) terminal.
4. Remove the 12volt auxiliary battery.
5.
2008 – 2010 Models
2011 Model
21