Maintenance Of Your Water Heater - American Water Heater 6510381 Installation Instructions And Use & Care Manual

MAINTENANCE OF YOUR WATER HEATER

Draining and Flushing
It is recommended that the tank be drained and flushed
every 6 months to remove sediment which may build up
during operation. The water heater should be drained if
being shut down during freezing temperatures. To drain the
tank, perform the following steps:
1. Turn off the gas to the water heater at the manual gas
shut-off valve.
2. Close the cold water inlet valve.
3. Open a nearby hot water faucet.
4. Connect a hose to the drain valve and terminate it to an
adequate drain.
Note: The drain hose should be rated for at least 200°F.
If the drain hose does not have this rating, open the cold
water inlet valve and a nearby hot faucet until the water is
no longer hot.
5. Open the water heater drain valve and allow all the
water to drain from the tank. Flush the tank with water
as needed to remove sediment.
6. Close the drain valve, refill the tank, and restart the
heater as directed under "Operating Your Water
Heater".
If the water heater is going to be shut down for an extended
period, the drain valve should be left open.
Important: Condensation may occur when refilling the
tank and should not be confused with a tank leak.
Routine Preventative
Maintenance
At least annually, a visual inspection should be made of
the venting and air supply system, piping systems, main
burner, pilot burner, and flame-trap. Check the water heater
for the following:
• Obstructions, damage, or deterioration in the venting
system. Make sure the ventilation and combustion air
supplies are not obstructed.
• Build up of soot and carbon on the main burner and
pilot burner. Check for a soft blue flame.
• Leaking or damaged water and gas piping.
• Presence of flammable or corrosive materials in the
installation area.
• Presence of combustible materials near the water
heater.
• Verify proper operation after servicing this water heater.
Important: If you lack the necessary skills required to
properly perform this visual inspection, you should not
proceed, but get help from a qualified service technician.
20
Temperature and Pressure
Relief Valve
Explosion Hazard
If the temperature and pressure relief
valve is dripping or leaking, have a
qualified service technician replace it.
Do not plug valve.
Do not remove valve.
Failure to follow these instructions can
result in death or explosion.
Manually operate the temperature and pressure relief valve
at least once a year to make sure it is working properly.
To prevent water damage,
the valve must be properly
connected to a discharge
line which terminates
at an adequate drain.
Standing clear of the outlet
(discharged water may be
hot), slowly lift and release
the lever handle on the
temperature and pressure
relief valve to allow the valve to operate freely and return to
its closed position. If the valve fails to completely reset and
continues to release water, immediately shut off the manual
gas valve and the cold water inlet valve and call a qualified
service technician.
Figure 21
Temperature and Pressure
Relief Valve
Manual Relief
Valve
Discharge line to drain