Asus A7S-VM User Manual page 39

3. HARDWARE SETUP
17) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power supply
fits in only one orientation because of the different hole sizes. Find the proper
orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
Make sure that the ATX power supply can supply at least 10mA
on the +5-volt standby lead (+5VSB). You may experience difficulty in turning
the system ON if the power supply cannot support the load. For Wake-On-LAN
support, the ATX power supply must supply at least 720mA +5VSB.
A7S-VM
A7S-VM ATX Power Connector
18) Power Supply Thermal Sensor Connector (2-pin PWR_TMP)
If you have a power supply with thermal monitoring capability, connector its
thermal sensor cable to this connector.
A7S-VM
A7S-VM Thermal Sensor Connector
+12.0 Volts
+5V Standby
Power Good
+5.0 Volts
+5.0 Volts
+3.3 Volts
+3.3 Volts
Power Supply Thermal Sensor
ASUS A7S-VM User's Manual
+5.0 Volts
+5.0 Volts
NC
Ground
Ground
Ground
Ground
Ground
Power Supply On
Ground
Ground
-12.0 Volts
+3.3 Volts
PWR_TMP
39