HD Intelligence BC78308 User Manual page 8

The IR receiver & blaster are unique to HDMI for network products.
The IR receiver & blaster are different shapes, so that they are not mixed up.
IR RECEIVER/ DECODER IR BLASTER/ ENCODE
With BC78309/BC84476
ENCODER
BC78308/
BC78307
8
Please do not use other types.
ONLY USE IR DEVICE SHAPES AS BELOW
3
1. Use only supplied power supply 2A 5V.
Make sure that the power supply is well ventilated.
2. HDMI IN. Connect with source using HDMI cable.
3. IR blaster 3.5 mm. Position in front of source device, do not cover the IR
window
4. RJ45 LAN output. Using Cat 6 cable connect to RX decoder or network.
5. The RESET button is used if the picture quality is not normal or flashing.
Press the reset button for at least 3 second. On release the picture will return
after a few seconds.
NOTE! It is recommended that the RX is secured by screws, not tape.
Cables should be secured with cable ties so that minor movement will not
dislodge them from there correct location.
With BC78308/BC78307
Layout & Connection Proceedure
1 2
4 5
IR Receiver & Blaster
TX FRONT
TX BACK