DECODER
BC78309/
BC84476
6. Use only supplied power supply 2A 5V.
7. HDMI OUT Connect to TV using HDMI cable.
8. IR Receiver 3.5 mm.
9. RJ45 LAN input. Connect to TX encoder or network.
10.The RESET button is used if the picture quality is not normal or flashing.
NOTE! It is recommended that the RX is secured by screws, not tape.
Cables should be secured with cable ties so that minor movement will not
dislodge them from there correct location.
8
Make sure that the power supply is well ventilated.
Position near TV so that remote operation of the source is possible.
Some experimentation is recommended for best results as lights, reflections
and TVs can affect the IR stability.
Press the reset button for at least 3 second. On release the picture will
return after a few seconds.
Layout & Connection Proceedure
6
7
9
10
RX FRONT
RX BACK
9