Advertisement
2.
Operation
Connect the NL-324BTR to the Car charger port. The blue LED should start blinking now. If it doesn't blink, please start the ignition.
Thus the power supply port will be activated by the ignition. Do not clean the contacts of the female port on your own. We recommend
you to get it done by a car specialist.
3.
Bluetooth link
You can connect the device to any PNA/PND/PDA/Smartphone etc. which is equipped with a SPP compatible Bluetooth. For a
reasonable operation you need a navigation software which supports the GNS protocol. At first please start the NL-324BTR, by
plugging it into the cigarette lighter port. The blue LED should now blink. For some cars you need to start the ignition. Now start the
Bluetooth manager on your PNA/PND/PDA/Smartphone etc. Follow the instructions on the display or may consult the manual of your
PNA/PND/PDA/Smartphone etc. In case a PIN is required, please enter "0000". For Windows mobile 5 you need to set the serial port
manually. After setting the COM ports, please leave the Bluetooth manager and start your navigation. Enter the given COM port no.
into your navigation software as TMC-port.
4.
FM Antenna
For receiving TMC a FM antenna is required. Use the included rod antenna or when having low reception signals, the loop antenna.
Mount the loop antenna with the suction cup vertically to the windscreen. Due to the laws of physics the VHF reception inside a
vehicle is not as good as inside. If you should not receive a TMC channel at your place, this could be caused by insufficient range of
the VHF channel or the difficult reception conditions. Mountains, valleys, forests and deep street canyons may lower the reception or
prevent it completely.
5.
Charging function
The NL-324BTR has a power port for your PDA/ PND/ Smartphone. Thus a permanent operation is given. The integrated charging
electronic is limited for devices of up to 1A. The included cable is suitable for devices with standard mini USB female port
6.
Malfunction
The Navilock repair center aims to be as fair as possible. Therefor we kindly ask you to give us the true reason for a defect. During
the fault analysis, the support needs to find out if a third party, a water damage, a downfall damage, over voltage or wrong handling
might be the reason for that.
Often malfunctions are caused by minor errors. It is not always necessary to immediately replace a product, because this will not
correct a malfunction that is not caused by the GPS hardware.
Before contacting your dealer, please contact Navilock support. This will provide you with help in a fast and easy manner, and help
avoid unnecessary replacement.
In such cases, describe the malfunction as accurately as possible in writing, add the details for your device and the software you are
using, and send an email to support@navilock.de.
A member of the support team will take care of your problem and work on a solution. We hope you enjoy your Navilock product!
Advertisement
