These guidelines do not cover every possible condition or situation that may occur. Be safe using common sense and caution when installing, operating and cleaning this appliance. If you are unsure about any of these instructions or warnings, contact SunDanzer or your local product dealer for assistance. TABLE OF CONTENTS IMPORTANT NOTES ……………………………………………………………..
At the delivery, please check that the appliance is complete and has not been damaged during transport. It is not advised to connect an appliance that has been damaged, especially damage to the electrical supply cable or refrigerant circuit. In the event of damage please contact SunDanzer or your local product dealer for assistance. General Safety •...
At the end of the appliance life When disposing of your appliance, use an authorized disposal site. The refrigerant must be completely drained and collected by an authorized technician for recycling prior to disposal. Check with your local Environmental Agency for recommendations on recycling this appliance in your area.
Page 5
Electronics Diagram or 7.5A fuse Fuse A fuse is required in order to protect the wiring. A standard automobile fuse is recommended and the Operating Voltage Fuse fuse should be wired to the positive (“+”) side of the system close to the positive battery terminal. For 7.5A 12V operation, use a 15A fuse, and for 24Voperation use a 7.5A fuse.
OPERATION The SunDanzer refrigerating appliance, like any battery-powered refrigerating appliance, requires care unique from appliances plugged into an electric utility. Prudent operation is the key to extended service. Starting the Appliance After the appliance has been properly connected to the 12 or 24 VDC power source, the compressor will automatically turn on and the cabinet will begin cooling.
DEFROSTING • Before any cleaning or repositioning is carried out, you must DISCONNECT the appliance from the electrical power supply. Freezer Defrosting The appliance compartment will become progressively covered with frost. This should be removed periodically with a plastic scraper (provided with some units). However, when the ice becomes very thick on the interior walls, complete defrosting should be carried out.
TROUBLE SHOOTING Before contacting a service technician, SunDanzer or your local product dealer, check the following points. If you call out a technician to a fault listed below, or to repair a fault caused by misuse, abuse, or faulty installation, a charge will be made even if the appliance is under warranty.
WORKMANSHIP AND MATERIAL FOR A PERIOD OF ONE YEAR FROM THE PURCHASE DATE. THIS WARRANTY SHALL BE LIMITED TO REPAIRING OR REPLACING, AT SUNDANZER’S OPTION AND WITHOUT CHARGE TO THE PURCHASER, DEFECTIVE COMPONENTS. ALL WARRANTY WORK SHALL BE PERFORMED AT A SUNDANZER APPROVED FACILITY.
Need help?
Do you have a question about the DC50 and is the answer not in the manual?
Questions and answers