Related Manuals for SunDanzer DCR50
Summary of Contents for SunDanzer DCR50
- Page 1 DC-Powered Refrigerator & Freezer DC50 User’s Guide SunDanzer 420 E Aviation Drive Suite 130 Tucson, AZ, 85714 USA Rev. 10/26/20...
-
Page 2: Important Notes
At the delivery, please check that the appliance is complete and has not been damaged during transport. It is not advised to connect an appliance that has been damaged, especially damage to the electrical supply cable or refrigerant circuit. In the event of damage please contact SunDanzer or your local product dealer for assistance. Rev. 10/26/20... - Page 3 General Safety • Before cleaning or repositioning the appliance, always disconnect from the electrical power supply. • Service the appliance only if you are a trained or authorized refrigeration technician. • This appliance contains refrigerant R-600a and a polyol-ester compressor oil in its refrigerant circuit. Take utmost care when handling your appliance so as to not cause damage to the refrigerant circuit with consequent possible leakage.
-
Page 4: Installation
The unit will automatically operate on either 12 or 24 VDC. The user does not need to make any adjustment. • This unit will not operate directly from a PV solar module. Contact SunDAnzer if you prefer this option. • THIS APPLIANCE MUST NEVER BE CONNECTED DIRECTLY TO ANY AC (Alternating Current) POWER SOURCE! •... - Page 5 • If the appliance has been handled standing on its side or on end, it should be allowed to stand in the normal operating position for 12 hours before turning it on. Electronics Diagram (Direct Battery connection example) or 7.5A fuse Fuse A fuse is required in order to protect the wiring.
-
Page 6: Operation
OPERATION Once the wiring is complete and the refrigerator has 12 or 24VDC available, the unit will turn on automatically. The thermostat is also an on/off switch for the unit. When the dial is fully counter clockwise, the fridge will be off. Initial Cooldown Once on, the refrigerator will reach operating temperature in about 20 minutes. - Page 7 Opening and Closing the Lid The lid is fitted with a uniform sealing strip to prevent warm air and moisture from entering the appliance compartment. Be sure that the lid and the lid seal is free from obstructions and forms a complete seal around the rim of the cabinet. Overfilling and/or unlevel installation of the appliance will prevent a good seal.
-
Page 8: Cleaning And Maintenance
TROUBLE SHOOTING Before contacting a service technician, SunDanzer or your local product dealer, check the following points. If you call out a technician to a fault listed below, or to repair a fault caused by misuse, abuse, or faulty installation, a charge will be made even if the appliance is under warranty. -
Page 9: Warranty
WORKMANSHIP AND MATERIAL FOR A PERIOD OF TWO YEAR FROM THE PURCHASE DATE. THIS WARRANTY SHALL BE LIMITED TO REPAIRING OR REPLACING, AT SUNDANZER’S OPTION AND WITHOUT CHARGE TO THE PURCHASER, DEFECTIVE COMPONENTS. ALL WARRANTY WORK SHALL BE PERFORMED AT A SUNDANZER APPROVED FACILITY. - Page 10 WILL BE WARRANTED FOR THE BALANCE OF THE WARRANTY PERIOD WITH RESPECT TO THE ORIGINAL PURCHASED PRODUCT. SUNDANZER WILL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, LOSSES, OR EXPENSES ARISING FROM INSTALLATION, USE OR ANY OTHER CAUSES. THERE ARE NO EXPRESS OR IMPLIED WARRANTIES, INCLUDING MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH EXTEND BEYOND THOSE WARRANTIES DESCRIBED OR REFERRED TO ABOVE.
Need help?
Do you have a question about the DCR50 and is the answer not in the manual?
Questions and answers