Download Print this page
Cuno CFS6000 series Installation And Operating Instructions

Cuno CFS6000 series Installation And Operating Instructions

Water filter systems

Advertisement

Quick Links

INSTR4038 0302
Installation and
Operating Instructions
For CUNO
Food Service CFS6000 and CFS7000 Series Water Filter Systems
®
CFS6000 Series
Automatic Shut-off • Particulate and Chlorine Reduction •
Optional Scale/Corrosion and Cyst Reduction
Your new CFS6000 Series water filter system is designed
to be installed on the cold water line. The CFS6000 Series
features its own automatic shut-off, thereby eliminating
the need for a shut-off valve on the incoming supply line.
Note: It is advisable to install a drain valve after the system
for routine maintenance. A flush kit can be purchased sep-
arately if a drain valve is not desired. See the CUNO
Service Price List for part number and price.

INSTALLATION PRECAUTIONS

• The filter must be installed with the inlet and outlet as labeled. Make sure not to reverse connections.
• Do not install on hot water line. Maximum temperature allowed is 100°F (38°C).
• Do not install on line pressure above 125 psi (862 kPa).
• Do not use wicking or sealer for fitting connections into head of filter. Use Teflon
• Do not use torch or other high temperature sources near filter system.
• Do not install near electric wires or water pipes which will be in the path of drill when selecting the position to
mount the bracket.
• Do not install in direct sunlight.
• Protect from freezing. Drain filter when room temperature drops below 40°F (4.4°C).
• Allow minimum of 2" (5 cm) clear space under filter to facilitate cartridge change.
• Mount filter in such a position as to prevent it from being struck by other items.
• Installation must comply with existing state or local plumbing codes.
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system.
• Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
CFS7000 Series
Sanitary Quick Change (SQC) • Particulate and Chlorine
Reduction • Optional Scale/Corrosion and Cyst Reduction
Your new CFS7000 Series water filter system is designed
to be installed on the cold water line. This filter system
requires a shut-off valve installed on the inlet water line,
preferably near the filter for convenience.
®
Food
®
Tape for connections.
Teflon is a registered trademark of E.I. DuPont.

Advertisement

loading
Need help?

Need help?

Do you have a question about the CFS6000 series and is the answer not in the manual?

Questions and answers

Summary of Contents for Cuno CFS6000 series

  • Page 1: Installation Precautions

    Your new CFS6000 Series water filter system is designed Your new CFS7000 Series water filter system is designed to be installed on the cold water line. The CFS6000 Series to be installed on the cold water line. This filter system...
  • Page 2 Secure bracket to mounting surface using appropriate mounting hardware. The unit may be mounted either vertically or horizontally. Step 3. CFS6000 Series - The inlet/outlet connections are 3/8” female pipe threads. Appropriate fittings/piping/ tubing tools vary by requirements of each installation. The CFS6000 Series contains an internal shut-off valve in the filter head, therefore, no external shut-off valve is required.
  • Page 3 Replace cartridge when there is a decrease in water flow or when objectionable taste and/or odors return. It is recommended that the cartridge be changed at least every six months. Always have spare cartridges on hand. Changing CFS6000 Series Cartridges Step 1...
  • Page 4 CUNO will bear all the reasonable and proper shipping or mailing charges actually of the product to conform to this Warranty will be remedied by CUNO in the manner pro- incurred in the consumer’s return of the Product as set forth herein. If the Product vided below.

This manual is also suitable for:

Cfs7000 series