Advertisement
End
Pipe
"Plugs"
1. Carefully remove the panel from the box. A panel is made of 2 half panels attached together to form 1
panel assembly. This design allows for water to flow into, through, and then out of the panel assembly.
The 2 half panels are connected at the factory.
2. Remove the strap and unroll the panel assembly. Allow it to sit in the sun so that it will become more
flexible.
3. While the panel relaxes remove the hardware kit from the box and count all pieces to make sure they are
all there. (See picture of Hardware Kit and Parts List Page 4)
4. There is a male and a female Twist-Connect Elbow. Check to make sure the "O" Rings are in place on the
male side of the End Pipe and the male Twist-Connect Elbow. Make sure the support collar stays in place
on the female End Pipe fitting. (see Diagram B1 and B2) Attach both Twist-Connect Elbows to the proper
sides of the End Pipe.
Ensure "O" Rng
Ensure "O" Rng
INSTALLING (1) 20' ecoSAVER SYSTEM
Diagram A-2
1 - 20' Panel Assembly
B1: Male Twist-Connect Elbow connects to Female End Pipe Connection
is in place
B2: Female Twist-Connect Elbow connects over Male End Pipe Connection
is in place
Male Twist-Connect Elbow
with Hose Adapter
Female Twist-Connect Elbow
with Hose Adapter
Water Flow
Water Flow
5
Advertisement
