Glen Dimplex Nordic AS timer User Manual page 2

manufacturer:
Glen Dimplex Nordic AS
Havneveien 24, NO-7500 Stjørdal
Phone:+47 74 82 91 00
Fax: +47 74 82 91 01
e-mail: email@glendimplex.no
1150733G
TIMER USER MANUAL
W
hat this timer does-
This timer can be used to turn heaters on
and o on a weekly cycle. It has program-
mable On/O times with optional random
switching variations or it can be used as a
countdown timer.
Before starting-
Plug the heater into the wall outlet for at
least10 minutes to charge the internal
timer battery. The internal battery main-
tains current time and programs during
power outages.
Follow the instructions below to program
the timer.
The red ON or OFF indicator light is
illuminated when power is available at the
timer. When this light is on the heater
should also be on (if the ambient tempera-
ture is low)
The timer display will appear like this:
RST
MO
RND
0 0 : 0 0
auto
0 0
off
TIME
Setting the current time and day-
1. If this is the rst time setting the timer
reset the timer by pressing RST with a
pointed object otherwise skip this step.
2. Select between a 12 hr display (with AM
& PM) or a 24 hr display. To switch the
display: press and hold TIME for three
seconds. " 12:00am" denotes the 12-hour
clock.
3. Begin to set the current time by pressing
and holding SET (select) until "MO"(Monday)
ashes. Use  or  to select the current
day.
4. Momentarily press SET. The hour digits
will begin ashing. Use  or  to select
current hour. Ensure that current hour is AM
or PM.
5. Momentarily press SET. The minute digits
will begin ashing. Use  or  to select
current minute.
6. Momentarily press SET again and the
current time is now set.
The timer display will appear like this:
RST
FR
RND
2 1 : 2 2
auto
2 3
off
TIME
Programs and Features-
This section will demonstrate how to set a
programmed "ON" time and an "OFF" time. In
this case, program (PROG1) will be used
however this timer can store up to 20
ON/OFF programs which are active over a
week of time.
How to set an "ON" time:
1. Press  to select PROG 1 ON. "1 ON" will
be ashing.
2. Press SET and the day grouping will begin
to ash. Use  or  to select either a single
day or day-group. The possible selections
follow:
MO or TU or WE or TH or FR or SA or SU
(each day separate)
MO through FR (program runs each day
Monday through Friday)
SA and SU (program runs only on Saturday
and Sunday)
MO through SA (program same each day
Monday through Saturday)