Advertisement
Camera Installation
1. Remove the rear license plate.
2. Examine the vehicle to determine the best way to run the power wires
to the reverse lights and the extension cable through the car.
3. The Camera can be mounted above or below the plate. Determine the
mounting location that best suits your needs. Be sure to verify that
your installation plan complies with local laws and requirements.
Some states require that the state name, registration stickers, and
license number are not obstructed in any way.
4. Place the frame camera in front of the license plate and line up the
holes. Fasten the camera mounting bracket and the license plate to the
vehicle using the anti-theft screws provided. After installation of
screws with the tool provided, place the tool in the glove
compartment or other safe place for future use.
NOTE: To adjust the viewing angle, loosen the locking ring on the front
of the camera around the lens and then move the 'camera ball' to the
suitable angle and tighten the locking ring back up.
There is an alignment mark on the camera to show the top of the image.
5. Route the camera wiring into the vehicle. The wire can be run through
an existing grommet, behind a tail lamp, under the trunk molding, or
if necessary, through a 5/8 inch hole drilled near the vehicle's rear
5
Advertisement
