Tools Needed For Assembly And Adjustment - Delta 33-830 Instruction Manual

TOOLS NEEDED FOR ASSEMBLY AND ADJUSTMENT

Your Delta Radial Arm Saw can be assembled and adjusted using a few common hand tools, including:
• Phillips head screwdriver
• Flat blade screwdriver
• Framing Square
1. Loosen lock knob (A) Fig. 8, and move cutting-head
(B) to the rear position as shown. Then tighten knob (A).
2. IMPORTANT: Make certain the cutting-head is
clamped securely at the back of the track arm.
3. Place Radial Arm Saw on its back and assemble legs
(C) Fig. 9 (three of which are shown assembled) to each
corner of saw base (D) using sixteen 5/16-18 x 5/8"
carriage head screws (E), flat washers (G), external tooth
lockwashers (H), and hex nuts (J). Place flat washer on
bolt. Insert bolt through holes then assemble lockwasher
and nut. Hand tighten, hardware at this time but do not
completely tighten. Also refer to hardware Fig. 4.
4. Stand the saw in the upright position and securely
tighten all stand hardware.
ASSEMBLING WRENCH
HOOK TO SAW BASE
1. Assemble wrench hook (K) Fig. 10, to the front right
(as shown), or back left, side of saw base (D), using two
#10 x 1/2" shet metal screws.
ASSEMBLY
• 7/16" Wrench
• 1/2" Wrench
ASSEMBLING LEGS TO SAW BASE
• 1/2" Socket, ratchet, and extension
• Adj. Combination Square
B
C
9
• 3/16" Allen Wrench
• 1/4" Allen Wrench
A
Fig. 8
D
C
G
Fig. 9
D
K
Fig. 10
J
H
E