Fitting - Honeywell ICON-343C User Manual

PANEL CUTOUT
Fig. 3. – Controller – Panel-mount
(all dimensions are expressed in mm)
When fitting the controller, leave enough room at the rear to avoid compressing
or excessively bending the cables. The overall instrument dimensions and
panel cut out are given in Figure 3. below.
188
UUUUUUUUUU
149.5
ICON 343C / 363C USER GUIDE
12
Note: In order to access the screw
fixture (x2) please remove the front
facia, screw controller onto panel
and replace front facia.
Disconnect the power supply before you
begin installing the Icon controller. Do
not reconnect the power supply until you
have completed installation.
Please be aware that the relay outputs
are live when controller is powered up.
The contacts are NOT volt free.
Disconnect the power supply before you
begin any maintenance on the Icon
controller.
8

6.4. Fitting

SCREW FIXTURE
68
WARNING
EN2B-0004UK07 R0304
8