Listening To The Radio; Changing The Frequency Steps; Adjust [Settings] Mode Settings - Kenwood KDC-153 Instruction Manual

Item
SWITCH PRE REAR */ SUB-W: Selects whether rear speakers or a subwoofer are connected to the line out terminals on the
rear of the unit (through an external amplifier).
SP SELECT OFF */ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for optimum performance.

Listening to the radio

1 Press SRC to select "TUNER."
2 Press BAND repeatedly to select a band (FM1/ FM2/ FM3/ MW/ SW1/ SW2).
3 Press 4 / ¢ to search for a station.

Changing the frequency steps

You can change the frequency step of FM/MW:
FM : 50 kHz to 200 kHz
MW : 9 kHz to 10 kHz
1 Press and hold
2 While pressing number buttons 1 and 5, press
Release your fingers from the buttons after the display appears.
To restore the initial setting, repeat the same procedure.
When the frequency step is changed, the frequencies in the memory are deleted.

Adjust [SETTINGS] mode settings

While listening to the radio...
1 Press the volume knob to enter [FUNCTION] mode.
2 Turn the volume knob to select [SETTINGS], then press to enter.
3 Turn the volume knob to make a selection, then press to confirm.
See the following table for selection.
4 Hold to finish the procedure.
6
Selectable setting (Preset: *)
Hold for about 2 seconds to memorize the current station.
SRC to turn off the power.
SRC.