However, we suggest you read through this manual before starting out. If you then decide that installing straightened wire coat hanger works fine) your Acoustech Ceiling Speaker is a bit beyond your skills, we’ve included suggestions for locating sources A Phillips-head screw driver which will fit the of affordable outside help.
Con- Virtually any receiver, power amplifier or inte- versely, highs tend to be muffled by soft surfaces grated amplifier can be used with your Acoustech Standard Room such as drapes, rugs, upholstered furniture, car- Stereo Ceiling Speaker.
(lath and plaster If you like the designer white finish which has in older homes) acts as a superb speaker baffle. been applied to your Acoustech speakers, you CUTTING HOLES You can also install Acoustech speakers in can skip to Step D.
• Use the same 1-inch drill bit as before. 6. You now have cables running from the Acoustech Ceiling Speaker and also to the speak- • If you want a totally finished job, install an speaker. Time to get them down the wall er terminals on your amplifier or receiver.
Home Theater System Gently push on the rim of the tweeter to into tight spirals. If you have connected your new Acoustech swivel it so the center is aiming toward the 5. Attach the speaker wires to the red and black Ceiling Speaker to the rear “surround”...
There’s nothing wrong with driving your operate one Acoustech Ceiling Speaker and one 1. Short circuit at either the amplifier or Acoustech Speakers with a high power amp – other set of 8-ohm loudspeakers – or two sets speaker connectors is activating the amp’s the extra power helps them achieve quick of Acoustech Ceiling Speakers.
Need help?
Do you have a question about the HT-8C and is the answer not in the manual?
Questions and answers