Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Laney LC30-112
Summary of Contents for Laney LC30-112
-
Page 6: Before Switching On
BEFORE SWITCHING ON... -
Page 7: Specifications
SPECIFICATIONS Supply Voltage ~100V, ~120V, ~230V, ~240V 50/60Hz Factory Option Mains Fuse (~220V>240V = T630mA L 250V) (~100>120V = T1.6A L 250V) HT Fuse T315mA L Power Consumption 100W Output Power Rating Loudspeaker 12” Celestion 8 Ohms Loudspeaker outputs Extension speaker socket (Minimum 8 Ohm Impedance) Features Pure Class A Valve tone... - Page 8 INTRODUCTION...
- Page 9 Your LC30-112 should give you years of trouble-free amplification, however please take time to read this manual and familiarise yourself with the controls as it will allow you to get the best from your amplifier. We hope you enjoy using your LC30-112 as much as we enjoyed designing and making it.
-
Page 10: Front Panel Controls
FRONT PANEL CONTROLS HI INPUT: ‘Hi’ stands for high gain. This input is designed for the connection of low output level guitars making it well suited for guitars with single coiled or low gain humbucker type pickups. Use of high gain pickups in this input may drive the preamp too hard causing a "mushy"... -
Page 11: Drive Led
Switch in to enable the 'Drive' channel. (This switch must be in the disengaged position in order for the drive to be switched remotely via a foot switch.) DRIVE LED: This led will illuminate when the Drive channel is activated with the Drive switch (8) or an optional Laney FS2 remote footswitch. DRIVE: Sets the level of tube preamplifier drive or how dirty your sound is. -
Page 12: Rear Panel Controls
REAR PANEL CONTROLS Spare power fuse included in the tray. L Z B 1 2 3 4 POWER INLET SOCKET: Connect to your power source. Make sure the specified voltage is correct for your country! POWER FUSE: This drawer contains the main safety fuse for the unit. The fuse protects the AC power to the amplifier. USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL. - Page 13 FX return signal sounds. This is an insert type control, therefore you need to set the Dry/ Wet mix in your FX processor. FOOTSWITCH SOCKET: Provided for the connection of a Laney FS2 footswitch (optional) .This allows you to remotely switch between the clean/drive channel and & switch the built in reverb On/Off.
- Page 14 QUICK START SETTINGS - suggestions only, experiment! CLEAN CLEAN CRUNCH BLUES LEAD ROCK LEAD Suggested starting point, adjust Tone to individual taste...
- Page 15 USER SETTINGS - Store your own cool sounds...
- Page 16 • Tube amplifiers; generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due to the fragile glass tubes themselves. The LC30-112 uses top quality tubes, which should give you years of trouble free service, however like all tube amps; it is important to treat it with a certain amount of care.
- Page 17 your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds. Similarly when turning off your system always turn down the Volume controls on your guitar amplifier and then turn off its power before turning off other equipment.
- Page 18 LC30-112 SAMPLE SYSTEMS FX Controller GS412A...
- Page 19 NOTES...