Table of Contents
Advertisement
Repeat steps 2 through 7 for the taste/odor (FXUTB) filter cartridge in the Filter II sump
8
Open the filtered water faucet. Then, slowly open the water supply/saddle valve and allow the filter
9
housing to fill.
Close the filtered water faucet. Then, check for leaks between the sump and the head.
10
NOTE: If leaking, turn off the water supply and open the filtered water faucet. Then, disassemble the
filter and check the o-ring for cuts, flat spots, etc., and sealing surfaces for foreign material. Clean the o-
ring and lubricate with clean silicone grease. Carefully press into the groove in the sump.
The filter cartridges contain activated carbon. When new, open the filtered water faucet for ten minutes
11
to flush the system.
Fig. 5
Replacement label
Cartridge
O-ring seal
Sump
TURN SUMP
TO REMOVE
Filter II
Filter I
Bracket
Head
Sump
TURN SUMP
TO INSTALL
Sump
wrench
To
loosen
11
Advertisement
Table of Contents
