TRAINING MANUAL
FILTER ASSEMBLY and MOISTURE SENSOR
REAR BULKHEAD
AIR DUCT
DLEX8388WM
Remove the lint filter.
Remove three screws holding the cover
grid.
Remove the cover grid.
Disconnect the electrode sensors.
Remove the top plate, front cover, and tub
front.
Remove the belt and lift out the drum.
Remove 7 screws from the outside of the
rear cover, being careful the rear bulkhead
does not fall and cause internal damage.
Remove the rear bulkhead from inside the
dryer cabinet.
Remove the top plate.
Remove the front cover.
Remove the filter.
Remove 2 screws at the top of the air duct.
Remove the air duct.
Page 59
DLEX8377WM
STEAM DRYER