Table of Contents
Advertisement
BATTERY INSTALLATION
1. On the back of the remote control, push the tab and lift off the battery cover.
2. Obtain two (2) fully-charged AAA batteries. Match the
"+"
and "-" marks on the batteries
to the
"+"
and "-" marks in the battery case, then insert the new batteries.
3.~h~~~h=~~~h~~~~~~
should click when the cover is locked.
4. Test the unit by pressing POWER or any mode key. If the batteries are inserted correctly,
the selected mode key will blink once.
Notes
•
Do not leave the remote control in an extremely hot or humid place.
•
Do not use a new battery with old ones.
•
Do not mix manganese batteries with other kinds of batteries.
•
Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so
may cause a malfunction.
•
If you do not intend to use the remote control for an extended period oftime, remove
the batteries to avoid possible damage from battery leakage and corrosion.
•
When you replace the batteries, the remote buttons may be reset to their factory
settings. If this happens, reset the buttons again.
Tips
Under normal conditions, the batteries should last for about 3 months. When the remote no
longer operates the receiver, replace all the batteries with new ones.
·4 .
Advertisement
Table of Contents
