Download Print this page

Package Contents; Remote Control Battery Installation; Power Requirements - Curtis RT701A User Manual

7-inch atsc & ntsc tv receiver

Advertisement

PACKAGE CONTENTS:

7" TV (with
rechargeable battery)
Remote Control
(with 2 AAA Batteries)
AC Power Adapter
Car Adapter
Audio/Video Cable
Antenna
Instruction Manual

POWER REQUIREMENTS

You may use the AC power adaptor or the Car adaptor (NEGATIVE GROUND ONLY)
supplied for the power source.
AC power adaptor: AC input 100-240V, DC output 9V, 2A
Car adaptor: AC input 12V, DC output 9V, 2A
Ü The mains plug is used as disconnect device, the disconnect device shall remain
readily operable.
BATTERY INSTALLATION
Attach the rechargeable battery pack to the bottom of the TV Player unit as illustrated
below:
BATTERY COVER
NOTE:
This unit works either on the battery pack supplied or on DC power: unplug the DC Power
adapter from the DC input jack to run off the battery pack (after fully charged); plugging the
DC Power adapter while the battery pack is attached initiates the charging of this battery.
Please insert the battery correctly. Generally, it takes about 6 hours to charge a dead
battery pack full. A full charged battery pack can endure approximately 2 hours of
continuous playback.
BATTERY
2

REMOTE CONTROL BATTERY INSTALLATION

1. Remove the Battery Compartment Cover from the
back of the Remote Control.
2. Insert two "AAA" size alkaline batteries, observing the
proper polarity as indicated inside the Battery
Compartment.
3. Replace the Battery Compartment Cover.
CONTROLS
1
2
3 4 5 6 7 8 9 10 11 12 13
1. Power on/off switch
2. DC input jack
3. LCD display
4. Speaker
5. Standby/Power indicator
6. Menu
7. Channel -
8. Channel +
9.
Auto/
OK
10. Volume -
14
15
16
17
18
20
19
11. Volume +
12. Mode
13. Remote control sensor
14. RF in
15. Video in jack
16. Audio left in jack
17. Audio right in jack
18. Phones jack
19. Self-support Bracket
20. Battery compartment
3

Advertisement

loading