The First Wash Cycle - Hotpoint WTL 500 Instructions For Use Manual

As the colours of the wires in the lead may not
GB
correspond with the coloured markings iden-
tifyng the terminals in your plug, proceed as
follows:
Connect Green & Yellow wire to terminal marked
E or or coloured Green or Green & Yellow.
Connect Brown wire to terminal marked L or
coloured Red.
Connect Blue wire to terminal marked N or co-
loured Black.
If a 13 amp plug (BS 1363) is used it must be
fitted with a
13 amp fuse, either in the plug or adaptor or at
the distribution board.
If you are in any doubt about the electrical supply
to your machine, consult a qualified electrician
before use.
How to connect an alternative plug:
The wires in this mains lead are coloured in ac-
cordance with the following code:
BLUE
BROWN
GREEN & YELLOW
Disposing of the appliance:
When disposing of the appliance please remove
the plug by cutting the mains cable as close as
possible to the plug body and dispose of it as
described previously.
GREEN &
YELLOW
BROWN
BLUE
! The washing machine should not be installed in
an outdoor environment, not even when the area
is sheltered, because it may be very dangerous
to leave it exposed to rain and thunderstorms.
! When the washing machine is installed, the
mains socket must be within easy reach.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent
or dangerously compressed.
! The power supply cable must only be replaced
by an authorised serviceman.
4
NEUTRAL (N)
LIVE (L)
EARTH (E)
13 ampere fuse
CROSS-BAR
CORD GRIP
Warning! The company denies all liability if and
when these norms are not respected.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle 2.