Table of Contents
Advertisement
7. Position the docking case so its mounting holes align with the drive bay's
mounting holes. Secure with the supplied mounting screws (two/four on
each side.)
8. Attach the red SATA cable from the back of the unit to an available SATA port
on the system board or anySATA controller card. Connect the red and white
HDD Access/Activity signal cable to the HDD signal pins on your system board.
9. Connect an available 4-pin power cable from the system's power supply to
the 4-pin connector on the back of the docking case. The power connector is
'D' shaped to ensure proper orientation when making the connection.
Docking Module Data Cable and Power Connectors
10. Replace the computer's cover and reconnect the power and other external
cabling.
Mounting a Drive in the Drive Case
Proceed with the following steps to install a 3.5-inch drive device in the Mobile Rack
drive case.
1.Remove the Mobile Rack drive case cover by removing the two mounting screws,
then sliding the cover towards the back of the unit.
Slide Cover Off
Aluminum Mobile Rack
HDD Access
Remove the Drive Case Cover
Serial ATA (SATA) cable
Mounting
Screws (x2)
3-7
Advertisement
Table of Contents
