Download Print this page

Advertisement

Quick Links

V-037 Easy Guide
UK SERVICE & HELP - VAX CARE 0870 6061248
Mon-Fri. 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at the UK national rate.
Please make a note of the serial number and model number of your VAX before calling. There are over 400 approved VAX Service Agents in the UK . For your nearest Service Agent please call VAX Care.

Advertisement

loading

Summary of Contents for Vax V-037

  • Page 1 Mon-Fri. 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at the UK national rate. Please make a note of the serial number and model number of your VAX before calling. There are over 400 approved VAX Service Agents in the UK . For your nearest Service Agent please call VAX Care.
  • Page 2: Parts Checklist

    Parts checklist FRONT BACK Hanging loop 11 Charger Vac on/off button 12 Multi Hard Floor cleaner Vac on/off lock 13 Solution dispensing trigger Mid-handle grip 14 Solution tank release button Cleaning solution tank 15 Charger input Dust canister release button 16 Charging indicator Dust canister Mop head...
  • Page 3 Putting your cleaner together Charging NOTE: Only use the charger supplied. CHARGE 24 HOURS BEFORE FIRST USE. Top view of cleaner Notch To assemble the handle: To disassemble the handle: Use a ball point Connect the charger to a wall socket. Plug the charger end into the side of the unit.
  • Page 4: Recommended Use

    Storage Recommended use Use the storage hook to hang the cleaner up. Use the dry vacuum to remove loose dirt and debris Wet mop by dispensing the cleaning solution and NOTE: Hang in a place convenient for charging. from floors. using an absorbent pad to remove dirt and grime.
  • Page 5 Operating the Vac ‘n’ Mop FOR ADVICE ON CLEANING SOLUTIONS AND ABSORBENT CLEANING PADS, PLEASE CALL VAX CARE ON 0870 6061248. NOTE: This product is intended for dry pick up only. Do not attempt to vacuum up any liquids with this cleaner.
  • Page 6 Operating the Vac ‘n’ Mop Prepare Vac’n’Mop Unscrew the cap from the top of the cleaning solution Mix one cupful of the Multi Hard Floor cleaner per litre NOTE: If needed, the solution tank can be removed tank. of water and pour into the solution tank. Replace the from the body of the unit.
  • Page 7 Operating the Vac ‘n’ Mop Vacuum To turn the vacuum on: Push the on/off button down (a). For best results, clean one small area at a time. Spray the solution by holding the trigger down for 3-4 seconds. This will dispense enough solution to clean approx 1 To lock the vacuum on: Slide the lock button forward (b).
  • Page 8 Dust canister and filter: removal IMPORTANT: FOR BEST RESULTS, CLEAN THE FILTER AFTER EACH USE. FOR ADVICE ON FILTER REPLACEMENT, PLEASE CALL VAX CARE ON 0870 6061248 NOTE: This product is intended for dry pick up only. However, if a wet spill is accidentally vacuumed into the dust canister, the filter should be rinsed thoroughly, then allowed to air dry completely before re-using.
  • Page 9 Dust canister and filter: removal Slot Return the filter to the filter protector and return to the Re-attach by aligning the tab on the dust canister with Tilt and push the dust canister until it locks into place. dust canister. the slot on the body of the unit.
  • Page 10: Troubleshooting

    NOTE: You must never use ordinary batteries for replacement, as these may leak and cause damage. This product contains Nickel-Cadmium battery and must be disposed of properly. For disposal information, call the VAX care helpline on 0870 6061248 VAX CARE 0870 6061248...
  • Page 11 • Do not spray solution toward people or pets. • If your VAX fails to operate, never attempt to repair it yourself, as repairs carried out by an unauthorised or inexperienced person may cause injury to you or damage to your VAX. Never alter the specification or modify your VAX in any way.
  • Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: VAX Limited, hereby on our own responsibility declare that the product Vac ‘n’ Mop is manufactured in compliance with the following: Safety: 72/23/EEC Low Voltage Directive as modified by 93/68/EEC EMC: 89/336/EEC Electromagnetic compatibility Directive as modified by 93/68/EEC VAX Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 0QH, UK...