Vax Detalier V-038 Easy Manual

V-038 Easy Guide
Please read these instructions carefully before using the Vax Detailer.
For advice or assistance, call
g
f
a On/off button
Filter inside dust container
b
c Dust container
d Charging indicator
NOTE: Only use the C-038 charger supplied by Vax.
CHARGE FOR 24 HOURS BEFORE FIRST USE.
1. Connect charger unit to mains socket outlet.
2. Plug the charger into the charger inlet on the charging base, ensuring that the dust
container nozzle interlocks with the tab nearest the charging indicator. Push the
handle down until it clicks securely into place. The charging indicator will light when
the unit is charging.
1. Remove the cleaner from the charging base.
2. Press the power button and hold down to vacuum dry dust and debris. Release to
shut cleaner off.
DUST CONTAINER AND FILTER: REMOVAL AND REPLACEMENT DUST CONTAINER AND FILTER: REMOVAL AND REPLACEMENT DUST CONTAINER AND FILTER: REMOVAL AND REPLACEMENT DUST CONTAINER AND FILTER: REMOVAL AND REPLACEMENT
1. Grasp the dust container and remove by gently pulling away from the main body.
2. Pull the filter out and empty contents into a waste bin. Remove any extra debris
from the filter and then replace in the dust container.
3. To replace the filter, line up the 3 notches in the filter with the 3 tabs on the dust
container. Firmly press the filter into the dust container and check the alignment of
the filter. NOTE: Dust may escape through the vents if the filter is mis-aligned.
4. Re-attach the dust container.
1. Slide the brush attachment into the vacuum nozzle as needed. Remove when finished.
2. Store on charging base when not in use.
The Vax Detailer is designed to sit in the charging base on a flat surface or mounted
vertically on a wall.
Vax Care
PRODUCT FEATURES
a
e
CHARGING
HOW TO OPERATE
ATTACHMENT USAGE
CHARGING BASE/INSTALLATION
handheld vacuum for small spaces
0870 606 1248
on
b
c
e Charging base
f Brush attachment
g Charger inlet
h Charger
www.vax.co.uk
d
h