Advertisement
Hot and cold water faucets:
Before you start...
Check location where washer will
,I
I^
I,,,
De ~nstallea Proper lnstallatlon
Is
your responsibility
Make sure you
have everything
necessary for
correct installation
Grounded
electrical
outlet
IS required. See Electrical
requirements.
Standpipe
drain system: needs
a two-inch
minimum diameter
standpipe
with minimum carry-
Untape and open washer IId
Remove packages,
hoses, and
1
must be withln 4 feet (122
literature rack from washer
P
A 1 centimeters)
of the back of the
washer and provide water
pressure 5-100 PSI (34.5-689.6 KPa).
Laundry tub drain system:
needs a 20.gallon
(75 liter) laundry
I
4!!3
II
tub. Top of tub must be at least
34 inches (86 centimeters)
high
*
and no higher than 52 inches
(132 centimeters]
from bottom of
washer.
/
Tools needed for
InstaIIatfon.
.I
Parts supplied
for installation.
away capacity
of 17 gallons (64
liters) per minute. Top of star IdpIpe
must be at least 34
Inches (86 centimeters
high and no higher
than 52 inches
If a longer drain hose IS needed,
Part No. 388423 and the hose
extension kit, Part No. 285442, are
authorized
parts dist
Water heater:
set to deliver 140' F
) water to the washer
Protection
from weather:
do not
store or operate washer below 32 F
(O'C). See Use and Care Q/de
for
further information
Level floor: maximum slope under
-
washer1 inch (25 millimeters).
Remove parts from packages.
Check
that all Dads were included.
literature
package
4 drain hose
4 plastic strap
4 flat water
lter
hose washers
J~C: washers
4 literature rack
xature rack
(not supplied lied
with all models1
ielsl
4 hose clamp
e
2 front leveling
1 grounding
clamp
legs with nuts
and screw
4 wire form
Electrical
requirements
Prefix "3" Models.
240 Volts, 5.0 Amps.
50 Hz., 8 Amp. fuse.
Electrical ground is required
on this appliance.
A fused electrical
supply is required.
[Time-delay
fuse or circuit breaker is
recommended.)
It is recommended
that a separate circuit serving only
this appliance
be provided.
WARNING: AN EXTENSION CORD
SHOULD NOT BE USED WITH THIS
APPLIANCE. SUCH USE MAY RESULT IN
A FIRE, ELECTRICAL SHOCK, OR OTHER
PERSONAL INJURY.
Recommended
grounding method
Do Not, under any circumstances,
remove the power supply cord
grounding
prong.
For your personal safety, this appliance
must be grounded.
This appliance
is
equipped
with a power supply cord
having a grounding
plug.
To minimize possible shock hazard, the
cord must be plugged
into a mating
grounding
type wall receptacle,
grounded
in accordance
with local
codes and ordinances.
If a mating wall
receptacle
is not available,
it is
the personal responsibility
and
obligation
of the customer to have a
properly
grounded
wall receptacle
installed by a qualified
electrician.
See
Figures l-3 to determine
the proper
mating wall receptacle
for the power
supply cord plug equipped
with this
washer.
L...mJ-
240 Volt
grounding
type
wau
receptacle
Figure 4
Schuko
grounding
type
Pow~o;;PPIY
I'll
Figure 2
ALTERNATE SlYLE
grounding
type
wall
recsplacle
grounding
plug
II
Figure 3
PANEL A
Advertisement
