Peavey AAM 802 User Manual page 7

30
31
32
35
34
33
31. MONITOR SIGNAL/PFL LED:
Normally indicates that a signal is present in the monitor of –20 dBu or greater. If the Monitor
PFL switch (32) is depressed, it lights continuously to indicate that the monitor mix has been
assigned to the PFL mix.
32. MONITOR PFL Switch:
Connects the monitor's pre-fader signal to the PFL mix and switches the headphone source
from the L/R mix to the PFL mix.
33. MONITOR 1 FADER:
Sets the overall level of the monitor signal that is sent to the Monitor 1 Output jacks (6). The
optimum setting for this control is the "0" (unity gain) position.
34. MONITOR 2 FADER:
Sets the overall level of the monitor signal that is sent to the Monitor 2 Output jacks (7). The
optimum setting for this control is the "0" (unity gain) position.
35. MASTER LEFT/RIGHT FADERS:
Master L/R level controls. Since the tape and headphone outputs come from this mix, they
will also be affected by its adjustment. The output levels are monitored by the left and right
meters. The optimum setting for this control is the "0" (unity gain) position.
36. MONO OUTPUT FADER:
Sets the output of the Mono (L+R) signal found at the Mono Output (9).
29. LED METERS:
Two 12-segment LED arrays monitor the levels of the main
L/R outputs. The 0 dB reference level corresponds to
+4 dBu at the 1/4" jacks and XLR. (See 8.)
30. MONITOR PEAK LED:
Indicates that the monitor mix level is nearing the overload
36
point. It illuminates at +19 dBu and warns that gain or EQ
boost should be reduced. There is roughly 2 dB of
headroom remaining when it lights.
7