Microsoft Windows Nt; Video Driver Installation; Installing Display Drivers For Windows Nt 4.0 - Asus PCI-V775V2 User Manual

IV. Microsoft Windows NT

Video Driver Installation

Installing ASUS S3 series Display Drivers for Windows NT 4.0
After installing your graphics card, Windows NT will default
to standard VGA mode (640 x 480, 16 colors). The procedure
below describes how you install ASUS S3 series display driver
for Windows NT.
1. Boot Windows NT in standard VGA mode (recommended).
Run Windows NT Display program located in the Control
Panel, under Settings in the Start menu. Alternatively, po-
sition the cursor on the background of the desktop, click
the right mouse button, then select Properties from the
popup menu.
2. Select the Settings page.
3. Select Display Type...
4. Select Change... from the display options.
5. Select Have Disk...
6. NT will prompt you for the correct path, enter the path of
driver in CD-ROM such as D:\NT40 (assuming your CD-
ROM drive is letter D).
7. A list of ASUS S3 series video adapters will be displayed.
Select the one you are using, then click on the OK button.
8. Windows NT will once again prompt for confirmation. All
appropriate files are then copied to the hard disk.
9. Select Apply in Control Panel. Restart Windows NT. Win-
dows NT will start up using the S3 drivers.
10. NT will boot into a default mode and start the Display applet
allowing for mode selection.
ASUS PCI-V775V2 User's Manual 15