Advertisement
Handhold:
•
Loosen 4 screws of handle bracket.
•
Insert right and left handle unit into
bracket and fasten screws again.
Fibre -/ blade protection:
•
Mount protective cover to the gear head
and fasten it with help of the screws in-
cluded in delivery.
Speed Bowden cable:
•
Remove air filter cover.
•
Insert Bowden cable through adjusting
screw and fit end of Bowden control into
opening of throttle of carburettor.
•
Adjust Bowden cable with help of adjust-
ing screw with 1-2mm clearance.
Assembling cutting knifes
•
Loosen mounting nut on arbour of gear
head. Attention, Pay attention to left-hand
thread!
•
Remove pressure plate cover and lower
pressure plate.
•
Install cutting knife now and mount pres-
sure plate again.
•
Tighten fastening screw again.
•
Attached to upper pressure plate you will
find arrester bore. Insert e.g. hex wrench
to hold up screw and tighten fastening
screw by using a fitting wrench.
Assembling nylon cutter:
•
Loosen fastening nut on arbour of gear
head, pay attention to left-hand thread!
Page 8
•
Only remove pressure plate cover.
•
Screw nylon cutter on top of thread.
•
Attached to upper pressure plate you will
find arrester bore. Insert e.g. hex wrench
to hold up screw and fasten nylon cutter
by hand.
MAINTENANCE
•
Before carrying out maintenance opera-
tion please always switch off device and
unplug it.
•
Good, regular maintenance will extend
durability and improve cutting perform-
ance of your brush cutter.
•
Regularly check fast and correct seat of
cutting tools and if necessary adjust them
again.
•
Check correct seating off all screws every
10 operating hours. Loose screws ought
to be fastened again.
•
Remove dirt and debris from engine.
•
Check cylinder plate and air filter for
blockage and if necessary remove stick-
ing dirt, debris and so on.
•
Carefully remove dirt and debris from
muffler and petrol tank.
•
Check for loose or missing screws or
parts. Make sure that cutting tool is free
from debris and correctly mounted.
•
On mowing please protect yourself suffi-
ciently with protective cloth such as ear
protection, safety boots, tight-fitting cloth,
Helmet, safety gloves and protective gog-
gles.
•
While working with this machine please do
never wear any jewels as these could be
caught in moving parts and cause bad
injuries.
•
On starting brush cutter it may not touch
any objects.
•
Make sure that device is not defective or
incompletely or incorrectly mounted. In
that case please do not operate brush
cutter.
•
Before putting brush cutter down please
switch it off.
•
Handles of brush cutter should always be
dry, clean and not contain any remains of
petrol or oil.
•
Never operate brush cutter when you are
tired, have drunk alcohol or taken any
other drugs.
•
On cutting you should always work with a
high engine speed.
•
Also pay attention to the maintenance
information given by manufacturer and do
only use approved original spare parts.
•
Important: When working with cutting
blade always remove fibre head from
protective cover. But anyway never oper-
ate device without protective cover.
•
Attention! Sound pressure level given on
this item is only a measured reference
value. As it is very much depending on
operating environment it can vary in
every days use. Protect yourself and
other people according to the given val-
ues adequate from developing noise
exposure.
Page 5
Advertisement
