Washer Maintenance - Kenmore 2125 Series Use & Care Manual

7.
Select Wash Temps
Once you select a cycle, select the desired wash temperature
by turning the Wash Temps knob to the appropriate setting
based on your load. All rinses are tap cold.
NOTE: Always read and follow fabric care labels instructions
to avoid damage to your garments.
Wash Temps
Hot
Some cold water is added to save
energy. This may be cooler than
your hot water heater setting.
Warm
Some cold water may be added,
so this will be cooler than what
your previous washer provided.
Cool Lights
Warm water is added to assist
in soil removal and to help
dissolve detergents.
Cool Darks
Warm water is added to assist
in soil removal and to help
dissolve detergents.
Cold
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
8.
Select cycle options
Select the desired cycle options. If you are using fabric softener,
be sure to select Fabric Softener "On" option.
10
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
Dark colors that bleed
or fade
Light soils
Dark colors that bleed
or fade
Light soils
9.
Select Start/Pause/Unlock Lid
to begin wash cycle
Press the START/PAUSE/Unlock Lid button to start the wash
cycle. Filling is delayed for several minutes while load balance
is sensed. When the cycle has finished, the CYCLE COMPLETE
indicator will light up. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of metal
hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments, you
may do so during the first portion of the sensing step. Press
START/PAUSE/Unlock Lid; the lid will unlock once the washer
movement has stopped. This may take several minutes if the load
was spinning at high speed. Then close lid and press START/
PAUSE/Unlock Lid again to restart the cycle. If lid is left open
for more than 10 minutes the water will pump out.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load unbalance.
You will hear the hum of the spin prior to filling. This is normal
operation.

WASHER MAINTENANCE

WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.