HP dx7300 Technical Reference Manual page 154

Error Messages and Codes
A.3 Power-On Self Test (POST) Messages
Error Message
Invalid Electronic Serial Number
Network Server Mode Active (w/o
kybd)
101-Option ROM Checksum Error
1 10-Out of Memory Space for
Option ROMs
102-system Board Failure
150-Safe POST Active
162-System Options Not Set
163-Time & Date Not Set
164-Memory Size Error
201-Memory Error
213-Incompatible Memory Module
214-DIM Configuration Warning
216-Memory Size Exceeds Max
217-DIMM Configuration Warning
219-ECC Memory Module
Detected ECC Modules not
supported on this platform
301-Keyboard Error
303-Keyboard Controller Error
304-Keyboard/System Unit Error
404-Parallel Port Address Conflict
417-Network Interface Card Failure NIC BIOS could not read Device ID of embedded NIC.
501-Display Adapter Failure
510-Splash Image Corrupt
51 1-CPU Fan Not Detected
512-Chassis Fan Not Detected
A-2
Table A-2.
Power-On Self Test (POST) Messages
Probable Cause
Chassis serial number is corrupt. Use Setup to enter a valid number.
System is in network mode.
A device's option ROM has failed/is bad.
Recently added PCI card contains and option ROM too large to
download during POST.
Failed ESCD write, A20, timer, or DMA controller.
An option ROM failed to execute on a previous boot.
Invalid checksum, RTC lost power, or invalid configuration.
Date and time information in CMOS is not valid.
Memory has been added or removed.
Memory test failed.
BIOS detected installed DIMM(s) as being not compatible.
A specific error has occurred in a memory device installed in the
identified socket.
Installed memory exceeds the maximum supported by the system.
Unbalanced memory configuration.
Recently added memory module(s) support ECC memory error
correction.
Keyboard interface test failed (improper connection or stuck key).
Keyboard buffer failed empty (8042 failure or stuck key).
Keyboard controller failed self-test.
Current parallel port address is conflicting with another device.
Graphics display controller.
Corrupted splash screen image. Restore default image w/flash utility.
Processor heat sink fan is not connected.
Chassis fan is not connected.
www.hp.com Technical Reference Guide