GE DS4600 Owner's Manual page 11

About control features.
Throughout this manual, features and appearance may vary from your model.
(Appearance and
features may vary)
START/PAUSE
s Press twice to select the last cycle you used and start the dryer.
s If you have selected a new cycle, press once to start the cycle.
s If the dryer is running, press once to interrupt the cycle; press again to continue the cycle.
STOP
s This pad should not be used to interrupt or pause a cycle.
s Pressing this pad will cancel the current settings.
Estimated Time Remaining
Each time the dryer is used, it "learns" what types of loads you dry most often.
It takes this data and determines the approximate time it will take the load to dry.
As the cycle begins, you will see the approximate total cycle time in the display. Then lights
will flash in the display, and the SENSING light will flash. This means the dryer is continuously
monitoring the amount of moisture in the load. The lights will continue until the dryer senses
a low level of moisture in the load. At that point, the dryer will calculate and display the
approximate time remaining.
SIGNAL
Alerts you that the cycle is complete. The beeper will continue to sound every two minutes for
the next 6 minutes, until the clothes are removed. The clothes should be removed when the
beeper goes off so wrinkles won't set in.
On some models, press SIGNAL to turn the beeper on or off.
On some models, press SIGNAL to select low or high volume, or to turn the beeper off.
EXTEND TUMBLE
Minimizes wrinkles by adding approximately 20 minutes of no-heat tumbling after clothes are
dry. The beeper will sound every 90 seconds to remind you to remove the clothes. The EST.
TIME REMAINING display will show 00.
ADD TIME
(on some models)
This option can be used to extend drying time at the end of any cycle. Each time the pad is
pressed, 10 minutes is added.
ge.com
11