GE GDF510-540 Series Owner's Manual page 12

Problem Possible Causes
Suds in the tub Correct detergent
wasn't used
Rinse agent was spilled
Detergent left in Dishes are blocking the
dispenser cups detergent cup
Black or gray Aluminum utensils have
marks on dishes rubbed against dishes
Dishes don't dry Low inlet water temperature
Rinse agent dispenser is empty
Control panel responded Door latch may not be properly
to inputs but dishwasher seated
never filled with water
Water valve may be turned off
Stained tub interior Some tomato-based foods can
cause reddish stains
Tea or coffee stains
An overall yellow or brown film can • A special filter in the water supply line is the only way to correct
be caused by iron deposits in water
White film on inside surface—
hard water minerals
Dishwasher won't run Fuse is blown or circuit breaker
is tripped
Power is turned off
Control panel is locked
Reboot your control
What To Do
• Use only automatic dishwasher detergents to avoid sudsing. Cascade
Automatic Dishwashing Detergents have been approved for use in all
GE dishwashers .
• To remove suds from the tub, open the dishwasher and let suds dissipate.
Close and latch the dishwasher . Pump out water by touching the
Start pad once; then 30 seconds later, touch the
Start pad again . Repeat if necessary .
• Always wipe up rinse agent spills immediately.
• Reposition the dishes, so the water from the lower spray arm can
flush the detergent cup . See the Loading the dishwasher section .
• Remove marks with a mild, abrasive cleaner.
• Make sure inlet water temperature is at least 120°F .
• Select Heated Dry .
• Use Wash Temp Boost option .
• Select a higher cycle, such as
• Check the rinse agent dispenser and fill as required .
• Make sure the door is firmly closed.
• Make sure water valve (usually located under the sink) is turned on.
• Use of the STEAM cycle after adding the dish to the load
can decrease the level of staining .
• Remove the stain by hand, using a solution of 1/2 cup bleach and
3 cups warm water . NOTE: Do not use bleach on stainless steel
tub or inner door.
WARNING!
Before cleaning interior, wait at least 20 minutes after a cycle for the
heating elements to cool down . Failure to do so can result in burns .
this problem . Contact a water softener company .
• GE recommends Cascade Crystal Clear
mineral deposits from forming .
• Run dishwasher with citric acid to remove mineral deposits. Citric acid
(Part number: WD35X151) can be ordered through GE Parts . See back
cover for ordering information .
• Replace fuse or reset circuit breaker. Remove any other appliances from
the circuit .
• In some installations, the power to the dishwasher is provided through a
wall switch, often located next to the disposer switch . Make sure it is on .
• Unlock control panel. See the
• Turn off power to the dishwasher (circuit breaker or wall switch) for
30 seconds; then turn back on .
Wash Temp Sani (Sanitize)
to help prevent hard water
®
Getting started section .
GEAppliances.com
®
or Heavy.
12