Flashing display lights.
What It Means
This is normal.
The START/RESET pad
has been pressed.
Using the dishwasher.
Check the Water Temperature
The entering water must be at least 120°F and
not more than 150°F for effective cleaning and to
prevent dish damage. Check the water temperature
with a candy or meat thermometer. Turn on the
flatware, cookware and plastic.
Filling the Dispenser
Fill the rinse agent dispenser until it reaches the bottom
of lip inside the opening. Replace cap.
To check if rinse agent is needed:
On some models, remove the cap and look into the
On some models, press the clear center of the fill cap
2 or 3 times. If rinse agent fills the center of the cap, you
A full dispenser should last about one month.
If rinse agent spills, wipe up the excess.
What To Do
Allow the dishwasher to drain and reset before you start a new wash cycle.
Press the START/RESET pad to turn off the beeper. If the CLEAN light continues
to flash, call for service.
Press the START/RESET pad to turn off the beeper and the dishwasher will
attempt to reset. Then restart the wash cycle. If this error continues, call for
rinse agent removes spots and prevents new film buildup on your dishes, glasses,
hot water faucet nearest the dishwasher, place
the thermometer in a glass and let the water run
continuously into the glass until the temperature