Sound And Volume Control - Teac Ghetto Blaster PBT1000 User Manual

BASIC OPERATION

Sound and Volume Control

ng volume can be done by rotating the VOLUME knob on this unit or the device you
- Adjusti
have already paired with.
- To enhance the quality of music, this powerful sound system comes with two additional
equalization functions. At anytime during playback, you can rotate the bass and treble knobs
for stronger bass/ highs.
NOTE: If there is no playback, ensure that the volume on both devices is not set to 0/Mute.
MP3 Playback via USB Thumb Drive or SD Memory Card
- To enter USB/SD Mode, press the FUNCTION key until "USB" or "SD" is on the display.
- The following chart shows how to use USB/SD mode:
KEY
DISPLAY MODE
FOLDER+/ FOLDER -
NEXT
BACK
PLAY/ PAUSE
P-MODE
STOP
NOTE: It takes time to read a large USB drive/SD card and count all the song files.
CAUTION - IMPORTANT: REMOVAL OF USB DRIVES & SD CARDS
Never remove SD cards or USB drives from the unit during playback. Always STOP playback,
then press the FUNCTION key to switch to another mode (RADIO/BT) before removing your
USB/SD memory device to prevent damage to your song files and memory devices itself.
Audio Line In (Aux Input)
This unit comes with 2 Aux Input sockets (AUX IN 1/AUX IN 2), allowing you to connect two
external devices at the same time. You can switch between the 2 Aux Input sources to "mix"
your music quickly.
- Connect your external player to this unit using a standard stereo (3.5mm to 3.5mm) cable.
- Press the FUNCTION key repeatedly until the display shows "AUX-1"/"AUX-2", depending on
which socket you have plugged into. Ensure your AUX-1/AUX-2 socket device corresponds
to the correct display.
- Start audio playback on the connected external player.
- Adjust the volume control of the main unit and your external device to the desired level.
NOTE: Playback control can be done only through your external device. Remember to switch
off the unit when you finish using the external device.
For USB thumb drive & SD Card
Switch between Spectrum Analyzer USB » Information » ID3 display
Choose folder location on your USB/ SD Card (Not usable in
RANDOM play mode)
Skip to the next song (Not usable in REPEAT 1 mode)
Skip to the previous song (Not usable in REPEAT 1 mode)
Start or pause music playback
Press repeatedly to switch between NORMAL PLAY » REPEAT 1 »
REPEAT ALL » REPEAT FOLDER » RANDOM PLAY
(NOTE: RANDOM PLAY is limited to songs within a selected folder
only.)
Press once: Stop playback (can be resumed from the same point)
Press twice: Reset playback memory (cancel resume)
6