GE GNSF18Z01 Owner's Manual page 6

About the water softener system.
6
RECHARGE TONIGHT
RECHARGE NOW
Control Settings Required
Upon installation and after an extended power outage. See the
When the transformer is plugged into the electrical outlet, 12:00 AM is flashing and
PRESENT TIME shows in the display area. Program the control as instructed below. If SR- -
is flashing, use the UP button to set the correct SR code as follows: SR17 for model
GNSF23Z, SR35 for model GNSF35Z and SR18 for model GNSF18Z. If you pass by the
correct code number, use the DOWN button. Then, press the SELECT button and program
the control.
If the wrong SR code shows for your model, see Manually Initiated Electronic Diagnostics section.
A "beeper" sounds while pressing buttons for control programming. One beep signals a
change in the control display. Repeated beeps mean the control will not accept a change
from the button you have pressed and you should use another button.
To set the control, you will use the UP, DOWN and SELECT buttons.
Set Present Time of Day
Upon installation and after an extended power outage. See the Program Memory section.
NOTE: If the words PRESENT TIME do not show in the display, press the SELECT button until
they do.
Press the UP or DOWN button to set. The UP button moves the display ahead; the DOWN
1
moves the time backward. If present time is between noon and midnight, be sure PM
shows . If present time is between midnight and noon, be sure AM shows
When the present time shows in display, press SELECT to set.
2
Set Water Hardness Number
NOTE: If 15 (factory default) and HARDNESS do not show in the display, press SELECT until
they do.
Press the UP or DOWN button to set your water hardness number in the display. DOWN
1
moves the display down to 1. UP moves the display up to the maximum setting.
NOTE: Each press of a button changes the display by 1 between 1 and 25. Above 25, the
display changes 5 at a time...25, 30, 35, etc. Holding a button in changes the numbers twice
each second.
When the water hardness number shows, press SELECT to set.
2
You can get the grains per gallon (gpg) hardness of your water supply from a water
analysis laboratory, or call and ask your local water department, if you are on a
municipal supply. (17.1 parts per million (ppm) =1 grain per gallon.)
SmartWater Softener System
TOUCH
or
TIME
HOLD HARDNESS
SELECT
Program Memory section.
.