Rear Panel - Sony HSR-X200P Operating Instructions Manual

Locations and Functions of Parts

Rear Panel

1 PC CARD slot
2 MIC connector
MIC
PC CARD
1 PC CARD slot
For PC cards of Type 2.
Insert a commercially available SCSI PC card to
enable data backup using a DDS tape drive. If you
insert a commercially available LAN PC card, network
control will be enabled.
2 MIC (microphone) connector (monaural
minijack)
Connect a microphone for audio recording.
3 AUDIO connectors (phono jacks)
IN: Connect an audio signal.
OUT: Connect to the AUDIO IN connector of a
monitor.
4 S-VIDEO connectors (Mini DIN 4-pin)
IN: Connect a Y/C-separated S-VIDEO signal.
LOOP OUT: The signal supplied to the IN connector
is output as-is. The signal is output even when the
power to the HSR-X200/X200P is off.
OUT: A Y/C-separated S-VIDEO signal will be
supplied. Connect to the S-VIDEO input of a
playback monitor. When the S-VIDEO signal is to
be monitored via a multiplexer, connect to the
S-VIDEO input of the multiplexer.
14
(GB)
3 AUDIO connectors
4 S-VIDEO connectors
5 VIDEO connectors
AUDIO
IN OUT
IN LOOP OUT OUT IN LOOP OUT OUT
S-VIDEO VIDEO
6 RS-232C connector
NON REC OUT WARNING OUT
ALARM CLOCK
RESET ALARM
COM IN OUT COM IN OUT FULL FULL
-AC IN
COM COM COM IN OUT COM COM
A B
REMOTE SW OUT
RS-232C SERIES
RS485
RS485
TERMINATE
ON
OFF
qa All Reset button
0 Control terminals
9 Alarm terminals
5 VIDEO connectors (BNC type)
IN: Connect a video camera. When using a
multiplexer, connect the video output connector of
the multiplexer to this input.
LOOP OUT: The signal supplied to the IN connector
is output as-is. The signal is output even when the
power to the HSR-X200/X200P is off.
OUT: Connect to the VIDEO IN connector of a
playback monitor. A composite video signal will
be supplied. Character signals are superimposed
on the output video signal. When the video signal
is to be monitored via a multiplexer, connect to the
video input connector of the multiplexer.
6 RS-232C connector (D-sub 9-pin)
An external controller, such as a PC, can be connected.
7 -AC IN connector
Connect AC power using the supplied AC power cord.
8 Power cord holder
Secure the AC power cord using the supplied tie, as
shown below.
7 -AC IN connector
8 Power cord holder
Tie