Features; Specifications; Connections; Operation - NuForce Dia Instruction Manual

nur=orcE
Whatever component you want to plug in for exquisite audiophile-quality sound-without the bulky receiver-Dia translates
the digital audio signal to analog sound via high-quality 24-bit D/ A converters that operate exclusively at the data's native
sample rate for maximum clarity and detail. 1
'The maximum sample rate currently supported is 24-bit/792kHz.
Features:
0
1 pair industry-standard Toslink fiber-optic inputs, 1 coaxiai-S/PDIF input
0
S/PDIF inputs up to 24-bit/192kHz
0
Audiophile-grade D/ A converter for tow noise and clarity
0
The absence of capacitors in the signal path allows for heightened purity, lower distortion, a wider, deeper sound-
stage and better-detailed imaging.
0
High-performance, digital-controlled volume pot with remote control
0
High-efficiency analog switching-amplifier technology for low power consumption. without digital artifacts
0
Ultra high-speed switching frequency for high resolution
Specifications:
0
Input
• Digital: 2 x TOSLINK, 1 x RCA Coaxial 75-0hm
• Maximum sampling rate: 192kHz
• Resolution: 24-bits
0
Output
• Line Out (for Subwoofer) connection
• Speaker Output: Peak power: 30W x 2 (4 Ohm)
• Output power at 1% THD+N, A-weighted: 24W_x 2 (4 Ohm), 18W x 2 (8 Ohm)
0
THD+N
• 0.02%
0
Frequency response
• 20 to 20kHz+/- 1 dB
0
SNR
>
90dB A-weighted
0
DC Requirement
• 12-15V, up to 60W; 60W 100-240VAC worldwide voltages PSU is included.
0
Dimensions
• 6"
X
4 1/2"
X
1".
0
Weight
• 1
lb. Shipping weight 5 lb.
Connecting the Dia:
0
The Dia has 2 optical (Toslink) and 1 Coxial SPDIF digital inputs. Connect your digital sources to one or more of the
inputs. The Dia accepts normal PCM signal (also referred to as LPCM). It does not recognize encoded bitstreams (i.e.,
Dolby or DTS digital signals).
0
Speaker Output: Connect the left and right speaker cables to the output terminals. In order to avoid shorting out the
Dia, before turning on the power, make sure that the polarity of the speaker cables is properly terminated to the
loudspeakers and the Dia.
0
Line Out: The 3.Smm line out is for connecting to a subwoofer. Inserting a 3.5mm DOES NOT cut off the output and is
not meant for connecting to headphones.
Operating the Dia:
4
0
Power On: Push the knob once and release.
0
Input Select: When the Dia is On, pushing the knob cycles between Input 1, 2 and 3.
0
Volume: Rotating the knob clockwise raises the volume.
0
Power Off: Push and hold down the knob for 3 seconds.
Note: there is no memory. Once the Dia is off and turned back on, it reverts to the factory default volume and input 1.