Blades; Blade Inspection; Blade Replacement - Honda HRX217HYA Owner's Manual

Blade Inspection

1. Turn the fuel valve OFF
2. Disconnect the spark plug cap from the spark plug
3. Tilt the mower to the right side so that the fuel cap side is up. This
will help to prevent fuel leakage and hard starting due to
carburetor flooding.
4. Inspect the blades for damage, cracks, and excessive rust or
corrosion.
BLADE BOLTS

BLADES


A worn, cracked, or damaged blade can break, and pieces of
the damaged blade can become dangerous projectiles.
Thrown objects can cause serious injury.
Inspect the blades regularly, and do not operate the mower
with worn or damaged blades.
A dull blade can be sharpened, but a blade that is excessively worn,
bent, cracked, or otherwise damaged must be replaced.
NORMAL WORN BENT
If a blade is bent, take the lawn mower to an authorized Honda
servicing dealer for inspection.
Blade Mounting Bolt Inspection
Inspect the blade bolts for any signs of damage
or looseness. If they are damaged, they must
be replaced.
If they appear loose, a torque wrench must be
used to accurately tighten the blade bolts to the
required torque. If you do not have a torque
wrench, take your lawn mower to an authorized
dealer to have the bolts replaced or tightened.
Use only Honda Genuine blade bolts and
special washers, since they are specifically
designed for this purpose. Replacement part
numbers are on page 19.
(page 3).
(page
WARNING
NORMAL
TRAILING EDGE
EXCESSIVELY WORN
TRAILING EDGE
CRACKED
INSPECT WASHERS
AND BOLT HEADS
FOR LOOSENESS

Blade Replacement

1. Remove the two blade bolts with a 14 mm (6 point) socket
wrench. Use a wooden block to prevent the blades from turning
13).
when removing the bolts. Remove the blades
UPPER BLADE
LOWER
BLADE
BLADE
BOLT (2)
SPECIAL
WASHER (2)
2. Clean dirt and grass from around the blade mounting area.
3. Install the sharpened or replacement blades using the two blade
bolts and special washers as shown. Be sure to install the special
washers as shown below.
Operating the mower with only one blade will result in an
improperly seated blade that can be thrown from the mower
and seriously hurt or kill someone.
Always install both blades as a set.
The blade bolts and washers are specially designed for this
application. When replacing bolts and washers, use only Honda
Genuine replacement parts.
UPPER BLADE
4. Tighten the blade bolts with a torque wrench to the specified
torque. Use a wooden block to prevent the blades from turning
when tightening the bolts, as shown on
Blade bolt torque: 36 ~ 43 ft-lb (49 ~ 59 N·m)
If you do not have a torque wrench, have an authorized Honda
servicing dealer tighten the blade bolts.
If the blade bolts are not torqued properly, the blades could
loosen and be thrown from the mower and seriously hurt or kill
someone.
Ensure the blade bolts are torqued properly.

WARNING
LOWER BLADE
BLADE BOLT [2]
AND WASHER [2]
SPECIAL WASHER
DIRECTION
page 12.
 WARNING
11