Page 1
User’s Manual IRL 20 IR Repeater Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan 1230 South Lewis Street Beeldschermweg 6C 135 Joo Seng Road, #04-01 Kyodo Building 68-1036-01 Rev. A Anaheim, CA 92805 3821 AH Amersfoort...
Page 2
Precautions Safety Instructions • English FCC Class A Notice Warning This symbol is intended to alert the user of important Power sources • This equipment should be operated only from the power source indicated on the product. This equipment is intended to be used with a main operating and maintenance (servicing) instructions Note: This equipment has been tested and found to comply with the limits for a power system with a grounded (neutral) conductor.
Page 3
Cut a length (150'/45 m or less) of Extron Comm-Link cable to go between the MediaLink Controller (MLC), MediaLink Switcher, System 5 IP Switcher, or AVT 100 and the IRL 20. See appendix A for cable part numbers. The maximum total distance between an Extron device (switcher, controller) and the IRL 20 is 150’...
IR remote control at UL Requirements ..............2-2 the IRL 20, and check for the appropriate response at the remotely Front and Rear Panel Features controlled Extron device........2-2...
™ Controller (MLC), MediaLink Switcher, System 5 IP Switcher, or AVT 100. The IRL 20 receives a signal via its front panel from an Extron IR remote operating at 38 kHz. It can also receive IR input via an optional Extron IR Sensor, which is smaller and less visible than the IRL 20.
30 feet of incoming signals are shown in the max. device that is even less visible than the IRL 20, you can cable an illustration at right. Extron IR Sensor (part #70-223-01) to this port, hide the IRL 20 within furniture, and place the IR Sensor’s receiver head in the Communications connector —...
AVT. Refer to An external, stand-alone power supply is only necessary if the the device’s manual for details on ports and pin IRL 20 is not connected to an Extron device that is able to assignments. supply power to it.
+12 VDC Ground ( ) and Accessories IRL 20 Specifications Included Parts External Accessories power supply Extron (12 VDC, 1 A max.) IR Remote Cables Stand-alone IRL 20 with power supply and IR Emitter IRL 20 • Installation and Operation...
Page 10
IR controller module ....Extron IR remote controls only parts to reorder IR output carrier frequency ..38 kHz IRL 20 60-580-01 Use the IRL 20 with Extron products only. 3.5 mm, 5-pole captive screw connectors 10-319-10 General 3.5 mm, 3-pole captive screw connector 10-319-13 External power supply ....
Page 11
Specifications, Part Numbers, Accessories, cont’d IRL 20 • Specifications, Part Numbers, and Accessories...
Need help?
Do you have a question about the IRL 20 and is the answer not in the manual?
Questions and answers