Table of Contents
Advertisement
Quick Links
im Vertrieb von
Extron Electronics, USA
Extron Electronics, Europe
1230 South Lewis Street
Beeldschermweg 6C
Anaheim, CA 92805
3821 AH Amersfoort
USA
The Netherlands
714.491.1500
+31.33.453.4040
www.extron.com
Fax 714.491.1517
Fax +31.33.453.4050
www.camboard.de
© 2002 Extron Electronics. All rights reserved.
CAMBOARD Electronics
Extron Electronics, Asia
Extron Electronics, Japan
135 Joo Seng Road, #04-01
Daisan DMJ Building 6F
PM Industrial Building
3-9-1 Kudan Minami
Singapore 368363
Chiyoda-ku, Tokyo 102-0074 Japan
+65.6383.4400
+81.3.3511.7655
Fax +65.6383.4664
Fax +81.3.3511.7656
Tel. 07131 911201
Fax 07131 911203
User's Manual
ce-info@camboard.de
IR Link
Infrared Signal Repeater
68-602-01
Printed in the USA
Advertisement
Table of Contents
Related Manuals for Extron electronics IR Link
Summary of Contents for Extron electronics IR Link
- Page 1 The Netherlands Singapore 368363 Chiyoda-ku, Tokyo 102-0074 Japan 714.491.1500 +31.33.453.4040 +65.6383.4400 +81.3.3511.7655 Printed in the USA www.extron.com Fax 714.491.1517 Fax +31.33.453.4050 Fax +65.6383.4664 Fax +81.3.3511.7656 www.camboard.de Tel. 07131 911201 ce-info@camboard.de © 2002 Extron Electronics. All rights reserved. Fax 07131 911203...
-
Page 2: Features
Reparaciones/mantenimiento • Solicitar siempre los servicios técnicos de personal particular use. In no event will Extron Electronics be liable for direct, indirect, or Precaucion calificado. En el interior no hay partes a las que el usuario deba acceder. Para evitar riesgo de electrocución, no intentar personalmente la reparación/... -
Page 3: Table Of Contents
..2-3 Rear Panel Connectors and Cabling ......2-5 Connecting an IR Link to a MediaLink Switcher ....2-6 Connecting an IR Link to a MediaLink Controller ....2-7 Connecting an IR Link to a power supply and an IR Emitter ................ 2-10 Front Panel Features and Operation ...... -
Page 4: Chapter 1 • Introduction
Vertrieb von CAMBOARD Electronics Table of Contents, cont’d IR Link Chapter One Introduction About the IR Link Features www.camboard.de Tel. 07131 911201 ce-info@camboard.de IR Link • Table of Contents Fax 07131 911203... -
Page 5: About The Ir Link
Extron product that uses 38 kHz carrier frequency IR signals. Infrared signals received by the IR Link are passed on to the Extron device, which can be installed out of the direct line of sight of the IR remote controls. -
Page 6: Installation Overview
Preparing the Site and Installing the Wall Box ments” on this page. The IR Link can be installed in a one-gang electrical wall box or To install and set up an IR Link, follow these steps: a mud ring-type mounting bracket. Choose a location that will allow cable runs without interference. -
Page 7: Rear Panel Connectors And Cabling
The MediaLink Switcher and MediaLink Controller provide box. The cables will be inaccessible after installation. 12VDC to the IR Link on pin B and a ground on pin A, so there is no need for an additional power supply. If the IR Link is used... -
Page 8: Connecting An Ir Link To A Medialink Switcher
Only three wires (between pins A, B, and D and the IR Link. on the IR Link end and pins C, , and + on the switcher end) are required. Wire the cable as shown in the following Attach a 3.5 mm, 5-pole captive screw connector to the end... - Page 9 Relay Control Modules User’s Manual for details on addresses and DIP switches. Plug one end of the cable into the IR Link’s remaining communications connector, and plug the other end into a communications connector on the control module. The...
-
Page 10: Connecting An Ir Link To A Power Supply And An Ir Emitter
Extron device to control that device. The output carrier +12VDC Ground ( ) frequency is 38 kHz, and the IR Link should be used only with Extron products. When you use the IR remote control, point it directly at this IR Link window for best results. -
Page 11: Testing/Troubleshooting
Installation and Operation, cont’d Testing/Troubleshooting IR Link Before installing the IR Link into the wall or furniture, test the system to make sure that the connections are correct and the IR Link is working correctly. Connect the cables between the MediaLink Controller or MediaLink Switcher and the IR Link, and connect the Controller or Switcher to a power source;... -
Page 12: Part Numbers
Vertrieb von CAMBOARD Electronics Specifications, Part Numbers, Dimensions Specifications Included Parts These items are included in each order for an IR Link: Control/remote — IR repeater IR controller module ....Extron IR remote controls only Included parts Part number IR output carrier frequency .. -
Page 13: Dimensions
PEM INSERT BSOS-440-16 OR EQUIV. INSERT FROM NEAR SIDE. (2 REQ'D) Ø.133 2.250 To install the IR Link without a THRU wall box, use the cut-out area (2.8" H x 1.9" W) indicated 1.450 by the dotted line. - Page 14 Vertrieb von CAMBOARD Electronics Specifications, Part Numbers, Dimensions, cont’d This page was intentionally left blank. This page was intentionally left blank. www.camboard.de Tel. 07131 911201 ce-info@camboard.de IR Link • Specifications, Part Numbers IR Link • Specifications, Part Numbers Fax 07131 911203...
- Page 15 Vertrieb von CAMBOARD Electronics Specifications, Part Numbers, Dimensions, cont’d This page was intentionally left blank. www.camboard.de Tel. 07131 911201 ce-info@camboard.de IR Link • Specifications, Part Numbers Fax 07131 911203...
Need help?
Do you have a question about the IR Link and is the answer not in the manual?
Questions and answers