HP Hewlett-Packard User Manual page 21

Troubleshooting Chart (Continued)
Condition
The printer prints only part of a
page or document.
The print job has been properly
sent, but the printer will not
print.
The IR status indicator turns off
during transmission.
PostScript™ print job will not
print.
EN
Solution
The connection has been broken during
transmission.
If you move the portable device during transmission,
the connection can be broken. IrDA-compliant
devices are designed to recover from temporary
connection interruptions. You have up to 40 seconds
to re-establish the connection (depending on the
portable device being used).
If the connection is broken before the entire print job
has been transmitted to the printer (printing has not
yet started), the printer may not print any of the job.
Press the Job Cancel
memory. Then, re-position the portable device within
the range of operation (see "Executing the Print Job"
on page 10), and print the job again.
The connection may have been broken, resume
connection within 40 seconds.
Press the Job Cancel
memory. Then, re-position the portable device within
the range of operation (see "Executing the Print Job"
on page 10), and print the job again.
Check configuration in the PostScript tab of
Windows: check that Protocol is set to AppleTalk,
and Binary Data is not selected.
HP Fast InfraRed Receiver 15
button to clear the printer's
button to clear the printer's