Operate Pedal; Brake And Clutch System; Power Steering - Opel ADAM Owner's Manual

Flashes when the engine is
running
Fault that could lead to catalytic
converter damage. Ease up on the
accelerator until the flashing stops.
Seek the assistance of a workshop
immediately.
Service vehicle soon
g illuminates yellow.
Additionally a warning message or a
warning code is displayed.
The vehicle needs a service.
Seek the assistance of a workshop.
Vehicle messages 3 94.

Brake and clutch system

R illuminates red.
The brake and clutch fluid level is too
low 3 155.
9 Warning
Stop. Do not continue your
journey. Consult a workshop.
Illuminates after the ignition is
switched on if the manual parking
brake is applied 3 127.

Operate pedal

- illuminates or flashes yellow.
Illuminates
Clutch pedal needs to be depressed
to start the engine in Autostop mode.
Stop-start system 3 122.
Flashes
Clutch pedal needs to be depressed
for a main start of the engine 3 17,
3 121.
On some versions the operate pedal
message is indicated in the Driver
Information Display 3 94.
Antilock brake system
(ABS)
u illuminates yellow.
Instruments and controls
Illuminates for a few seconds after the
ignition is switched on. The system is
ready for operation when the control
indicator extinguishes.
If the control indicator does not go out
after a few seconds, or if it illuminates
while driving, there is a fault in the
ABS. The brake system remains
operational but without ABS
regulation.
Antilock brake system 3 126.
Upshift
[ illuminates green as control
indicator, or is shown as a symbol in
the Driver Information Centre with
Uplevel-Display, when upshifting is
recommended for fuel saving
reasons.
On some versions gear shift
indication is popped up as full page in
the Driver Information Centre.
EcoFlex drive assistant 3 97.

Power steering

c illuminates yellow.
85