Audioplex VC75 IRTarget Installation Manual

INSTALL ATION MANUAL
IRTarget
Connector:
Mounting:
Remotes:
Range:
Acceptance angle:
Wire:
Power:

VOLUME CONTROL

Attenuator type:
Connector:
Power rating:
Frequency response: +0, -1 dB worst case(-6 dB tap), +0, -0.2 dB all other taps, 35 Hz-20 KHz,
Transformers:
Attenuation:
Your IRTarget is designed to act as a remote receiver and processor of infrared signals.
This sensor will receive signals from remote controllers and send these signals to a remote
repeater. This allows remote operation of any unit from the room where the VC IRTarget is
located. The addition of a 25 Watt volume control allows you the convenience of complete control
from a single plate.
CAUTION: Take care to make sure that the VC IRTarget installation is NOT IN THE LINE
OF SIGHT OR REFLECTION with the blinker(TM) repeater. If radiation from the repeater is
picked up by this sensor, a feedback situation is created which will result in instability and
unreliable operation. Undesirable reflection can occur off of light colored walls, windows, mirrors,
and even shiny wood finishes!
Any standard type of wire can be used. Shielded or coaxial cable is not usually required
unless the wire passes through some unusually high electrical interference regions.
Prepare the wire leads to and from the VC IRTarget by stripping about 1/4" of insulation
from each of the ends. Twist strands tightly together so that none stick out to cause a possible
short circuit. OBSERVE POLARITY! The sensor will not function if the wires are not in order.
TECHNOLOGY
VC75 IRTarget

SPECIFICATIONS:

Screw-type, 3 wire, non-removable.
Fits into most standard single electrical junction boxes.
Will handle almost all standard remote controllers (Note: does NOT work
with B & O equipment, which requires a proprietary confirmation talk-back
function).
110 feet indoors, 15 to 20 feet in direct sunlight.
+ or - 55 degrees off center.
Uses conventional unshielded "zip" or telephone wire.
12 VDC @ 500 mA power supply (not included).
Tapped auto transformer.
screw-tight type, removable
25 Watts RMS continuous, 35 Hz-20 KHz, 75 Watts audio.
measured at full power, 8 Ohm load. Most controls better these
specifications.
Tri-filar wound for flat response and minimum phase shift, grain orientated
high silicon steel laminations.
-34 dB in 12 steps, 8 steps @ -3 dB each, 1 step @ 4 dB, 1 step @ -6 dB,
last step OFF .

INSTALLATION:

TM
(Patent Pending)
1999 - 4/22/99